Spawning L260 Hypancistrus
By David Kozak
Aquarticles
L260 ready to spawn
Flush with the success of multiple spawns from my bristlenose plecos, I decided to apply
what I'd learned to a more difficult pleco. I bought two separate groups from Pembina
Petland: a group of four in April of 2004, and another group of 4 about 6-8 weeks later. I
spent the next 6 months conditioning the fish, and trying to sex them, (which is very hard
with fish that hide a lot ). The fish were housed in a 50 gallon bare-bottom tank, with an
air-driven sponge filter, a powerhead-driven sponge filter, and an Aquaclear AC-300
hang-on-back filter. This may seem like overkill, but they prefer alot of current-some say
it's necessary to get them to spawn. The tank temperature was approximately 26-28 degrees
celcius. The fish were fed mainly on frozen Hikari bloodworms, Hikari sinking carnivore
tablets, and Hikari algae/spirulina disks. While this may seem like a commercial for
Hikari, the fish really do seem to relish their food.
Looking for
males and females
After a few months of heavy feeding I began to think about cave design. I
tried caves made out of coconut shells, clay flower pot dishes, and (after reading of
other's successes on the internet) finally settled on long rectangular caves made out of
ceramic tiles. The caves were made slightly taller, almost 1.5 times the width, and twice
as long as the adult fish, with an end cap so that the male would be able to keep the
female in the cave to spawn with her.
By November, I decided that perhaps I had too many fish in one tank for them to feel
comfortable enough to pair off, so I removed them to pails to try and sex them. I’ve
been told that you can sex them by looking at them from above…the females especially
when gravid will look much more streamlined with a pointier face, whereas the males will
have a more blunt appearance to their face (and will never get gravid, of course-though I
have seen some pretty well-fed males). Another difference between males and females, is
the formation of a “feathery growth” around their gill area (interopercular
odontodes) which is often much longer in males. After making “best guesses” on
the fish, I took two of the fish into Petland for store credit, and ironically, I took
what was probably my best bet to be a male. I went back the next day to get him, feeling a
little embarrassed. After adding more caves to the tank, I re-doubled my efforts to get
them to spawn, by playing with the hardness of my water, and aiming the water current at
different areas of the tank. I also tried to simulate the dry season by letting the tank
conditions go a bit and not changing the water. A week or so before Christmas, I did a
really big water change on the tank bringing the hardness back UP ( my water is normally
Ph 7.5, Conductivity in the 600-700's depending on time of year).
I don’t believe that the softness or
hardness of the water played much of a roll in getting them to spawn. I think what was
necessary was the change in water parameters to “trigger” the spawn. Soon after
that I noticed the male seemed to have a female trapped in the cave. On Christmas eve he
released her and was sitting on a spawn of eggs. I began to see the first wigglers around
the 29th of December, and placed the ones that had escaped the breeding cave in a
netbreeder with an airstone. Shortly after that I removed the rest of the wigglers from
the cave and put those in the breeder net as well. Within a week they had absorbed their
yolksacs, and reached a length of almost a centimeter, showing the beginning of some
pattern. I began to feed them algae wafers and sinking carnivore tablets, which they
thrived on. They grew to almost 2 centimeters in the first 2 months and then growth slowed
down quite a bit.
Newly hatched
L260
Baby L260s
putting on weight in breeding net
Another view in
breeding net
I’ve tried both removing the wigglers from the parents to raise, and allowing the
parents to raise them, and I've seen smaller numbers survive from the parent raised
spawns. I feel this is because the fry don't get enough food spread over such a large tank
area. Whereas, in the breeder net, I can target feed them while still having the advantage
of a large tank for water quality. I've since had several more spawns with no effort or
special attention on my part.
All grown up and
ready for sale
|